Honeysuckle Bath Oil and Bath Salts: How to Disperse

Pour neat honeysuckle absolute into a running bath and it will not blend in. It floats, and the first thing to touch it is you. The good news is that the fix is simple: give the absolute a dispersant, a carrier, or both, and measure it by weight. Here are two bath formulations, a bath oil and a set of bath salts, built on that idea.

Honeysuckle Absolute bottle

Honeysuckle Absolute

Our own Honeysuckle Absolute, in sizes from 0.5 oz to bulk.

From $13.99

Shop Now →

What the bath guidance says

The Tisserand Institute is plain about it: essential oils are not water soluble, so poured straight in they leave a film of undiluted oil sitting on top, which can sting when it meets skin. Carrier oils alone do not disperse either, and they make the bath greasy and slippery, with fractionated coconut or jojoba suggested as the less greasy choices (Tisserand Institute, Bath Safety: how to use essential oils safely in the bath). That page is about essential oils. Honeysuckle absolute is a different material, but a thick, water-insoluble oil behaves the same way in a tub, so we apply the same reasoning.

The page names the dispersants: Solubol, polysorbate 20, polysorbate 80 and others. It says polysorbate 20 suits essential oils but not carrier oils, while polysorbate 80 can handle carrier oils. Both are suggested starting at 1:1 with the oil, and the page gives limits for each that are worded loosely enough that you should check the data sheet for the one you buy. Epsom salt, a popular idea, is not a dispersant, so mixing oil into salts alone leaves oil clinging to the grains. You will find dispersants, carriers and salts at a soap or cosmetic-supply shop; we sell only the absolute.

Bath oil, 100 g

IngredientGrams
Fractionated coconut oil or jojoba79.5
Polysorbate 8020.0
Honeysuckle absolute0.5

Warm the absolute bottle in your hand for a minute, weigh the absolute into the polysorbate first, and stir until clear. Then add the carrier and mix. The absolute is 0.5% of the batch, at the low end of our 0.5% to 2% skin guidance. At the relative density on our Certificate of Analysis (0.989), 0.5 g is about 10 drops, though weighing beats counting.

Shake and use a tablespoon per bath, about 14 g by our estimate, which carries around 0.07 g of absolute. In a 150 litre tub that is under one part per million. The figure is tiny on purpose: when the oil is dispersed through the water it is not sitting on your skin in a concentrated film.

Bath salts, 500 g

IngredientGrams
Dry bath salts500.0
Honeysuckle absolute0.5
Polysorbate 201.0 to 2.5

Mix the absolute with 1.0 g of polysorbate 20 in a small cup, in line with the 1:1 starting ratio, plus a bit more if the mix looks cloudy, up to 2.5 g. Drizzle it over the salts in a wide bowl and mix with a dry spoon, breaking up clumps. Use 100 g per bath, which carries 0.1 g of absolute, about two drops and roughly two thirds of a part per million in the same tub. Keep the jar dry and airtight, make only what you will use within a few weeks, and discard it if it turns damp or smells off.

Setting up the bath

Run the water first, then add the premixed oil as the tub fills, and swish it through with your hand before you step in. Keep a towel and a non-slip mat within reach. You will notice the scent rises with the warm steam, so you do not need to add more to make the room smell like honeysuckle. If you find it too strong, use less next time. The amounts above are small on purpose.

Afterwards, rinse the tub with warm water and wipe it down, so the next person to stand in it is not met by a slick surface. Wash the measuring spoon too, since oily residue builds up quickly. Store the bath oil capped, away from the shower spray, and shake it before each use, because the mixture can settle.

A word on enjoying it

Bath time is as much about slowing down as it is about scent. A small amount of honeysuckle in a warm room is plenty. We would rather you finish a little bottle you love than use a heavy hand and tire of the smell.

The real hazard is the floor

Oil makes tubs slippery, and bathrooms are where people fall. A CDC report estimated 234,094 nonfatal bathroom injuries among people aged 15 and older in 2008, with 81.1% from falls and 68.3% in or around the tub or shower (CDC, Nonfatal Bathroom Injuries Among Persons Aged 15 Years or Older, United States, 2008). The report does not mention bath oils, but the link is easy to make. Use a non-slip mat, step out carefully, and rinse the tub afterwards. Anyone with balance problems should ask a physician before adding oil to a bath.

Who should skip it

If you make these to sell, check the IFRA standards for your own bath product, since we cannot give a limit for it. For leave-on options, see the body oil, the whipped body butter and the sugar scrub, and see best carrier oils for choosing a carrier.

Weigh it, premix it, and the only thing left floating is you.

Honeysuckle Absolute bottle

Honeysuckle Absolute

Honeysuckle Absolute from our own shop, in sizes from 0.5 oz to bulk.

From $13.99

Shop Now →

Sources & Further Reading